What are the aspects of the use of Tianjin take-up machine

Tianjin take-up machine is used for wiring, wire drawing or wiring after rolling mill. According to the different wiring modes, it can be divided into I-wheel wiring mode, hollow coil wiring mode and vertical wiring mode. The middle of the car is provided with a main shaft, the upper end of the main shaft is provided with a large gear, and the large gear meshes with the small gear; the large gear is equipped with a wiring frame bottom plate, and the wiring frame bottom plate is equipped with a claw-shaped wiring frame.

Tianjin take-up machine is suitable for the winding of finished metal wires. The lifting force of the winding can be automatically adjusted during winding, and the walking pitch of the wire can be adjusted according to the diameter of the wire, so that the wire speed is coordinated with the previous process, the wire speed is tightly wound with the steel wire, and the wire appearance is neat and beautiful. Tianjin take-up machine is divided into electrical part and mechanical part. The electrical part includes control system and power part. The control system is used as the control of the take-up machine, which is used to operate the start-up and speed regulation operation of the take-up machine. The power part provides continuous power for the take-up machine. The mechanical part is composed of a wiring cylinder and a base.

Tianjin take-up unit has simple structure and simple operation. When installing, only use screws to fix the connector on the concrete floor, and keep a distance of 4-6m from the previous process equipment. Then the wiring, 380V power supply, the wire is connected to the speed controller, and the output end of the governor is connected to the torque motor.